Analysis of cutting performance in high density fiberboard milling by ceramic cutting tools
In order to study the cutting performance of TiC reinforced Al2O3 ceramic cutting tools in milling high density fiberboard, the effects of cutting parameter on the cutting forces, tool wear and cutting quality were investigated. Under the condition of same average chip thickness, feed per tooth and geometry angles, firstly, the change rate of maximum cutting forces were higher than that of average cutting forces at two different cutting speeds, and the cutting forces at high speed cutting was less than that at low speed cutting. Secondly, the flank wear at high speed cutting was more pronounced than that at low speed cutting, whose abnormal wear were pull-out of grain, cracking, chipping and flanking. Thirdly, the machining quality at high speed cutting was better than that at low speed cutting. Fourthly, the tendencies of cutting forces, tool wear and surface roughness relative to cutting length were similar, but the change rates were different, especially at the initial stage. Finally, high speed cuttingare plausible to use in HDF processing, which not only improves machining quality, but also promotes production efficiency.